4181 TCI Premium Lacquer Primer – Gray

Description Hi-Solids Acrylic Lacquer Primer PRODUCT DESCRIPTION: TCI Hi-Solids Lacquer Primer is a premium formula producing a fast drying and durable primer. Dries quickly, sands easily. Fills sand scratches and imperfections prior to topcoat application quickly. This primer can be topcoated with any automotive paint system.. FEATURES: • Excellent Adhesion Characteristics • Hi-Build, Superior Holdout • Fast Drying • Easy Sanding Properties • Can Be Top coated With Any Automotive Paint System • Indefinite Pot life! TCI 4181- Technical Information Sheet DESCRIPTION: 4181 Lacquer Primer 4181 is a high quality one-component primer surfacer. 4181 dries quickly and has good sanding and filling properties. It may be used under acrylic lacquers, acrylic enamels, alkyd enamels, urethane enamels and basecoat/clearcoat systems. INSTRUCTIONS: Sand original finish with medium grit sandpaper Clean all area with wax and grease remover Surface should be clean and dry before applying product Spray two or three medium coats of 4181, allowing each coat to flash to a dull appearance before applying the next coat. For best results force dry or allow to air dry for one hour before sanding 4181 can be block or machine sanded with P320 or P400, or wet sanded with P400 or P500 grit before applying topcoat GENERAL: 4181 Appearance -Gray Liquid Viscosity -Full Bodied Shelf Life -One Year (unopened) VOC -4.5 lb/gal (540 g/L) Pot Life -30 – 60 Minutes @ 75˚ F Product size -One gallon or quart cans PRODUCT MIXING: Mix one part 4181 with 1½ parts by volume lacquer thinner or urethane reducer. A reduction range of between 1:1 and 1:2 may be used depending on the desired viscosity and build. SUBSTRATES:  Coat large bare metal, steel & aluminum areas with proper self-etching sealer  Recommended substrate temperatures: 50˚ F – 100˚ F. GUN SET-UP TIP AIR PRESSURE Siphon Feed 1.8 – 2.0 mm 30 – 40 psi Gravity Feed 1.6 – 2.0 mm 25 – 40 psi HVLP (gravity) 1.6 – 2.0 mm 6 – 10 psi GUN CLEAN-UP: Clean equipment with a high quality lacquer thinner immediately after spraying TECHNICAL INFO: For additional technical information call (800-824-4999) SAFETY DATA: Refer to SDS for 4181 FOR INDUSTRIAL USE ONLY. TO PROTECT AGAINST HARMFUL VAPOR & SPRAY WEAR A POSITIVE – PRESSURE SUPPLIED AIR RESPIRATOR (NIOSH APPROVED), EYEPROTECTION, GLOVES AND PROTECTIVE CLOTHING WHILE MIXING AND SPRAYING. FOLLOW SDS FOR APPROPRIATE SAFETY AND HEALTH INSTRUCTIONS DISCLAIMER: The information contained on this Technical Data Sheet is intended to assist you in product application. It is based on knowledge of general industry use, experience & research. Since conditions of storage, handling, and product use are not under our control, buyers must assume responsibility for suitability of the product for their specific purposes.